The rules outlined in section 14.2.2 'Parsing Sequence Groups with Separators' are not properly specified, and probably cannot be consistently implemented. The last paragraph of Section 14.2.1 says this: "In the sections that follow, it is important to remember that the dfdl:separatorSuppressionPolicy property is carried on the sequence, while the XSDL minOccurs, XSDL maxOccurs and dfdl:occursCountKind properties are is carried on an element in that sequence." This is true, and this 'local overriding' of separatorSuppressionPolicy ( by arrays within the group ) is the cause of most of the problems. Problem #1: Complexity Consider a sequence group that has SSP='never' and the separator is a comma. Its members ( A,B,C ) must always be represented as follows: "a,b,c" or ",b,c" or ",,c" but never "b,c" because that would imply that the separator for an empty A had been suppressed. Now suppose that B is an array with minOccurs=0 and maxOccurs=3 and occursCountKind='implicit'. Acceptable representations are now: "a,b1,b2,b3,c" or "a,b1,,,c" or even "a,,,c" But if occursCountKind is changed to 'parsed' then the acceptable representations suddenly alter, and empty occurrences of B can be completely omitted. "a,b1,b2,b3,c" or "a,b1,c" or even "a,c" [ or should that be "a,,c" ] This seems wrong. The logic that implements suppression policy is hard enough to implement already. Bringing in an extra layer of complexity around arrays will make it so hard that most implementations would contain defects, leading to interoperability issues. Problem #2 Ambiguity See the brackets in the preceding paragraph. [ or should that be "a,,c" ] It is far from obvious whether the group should insist on having a delimiter for the array ( because its SSP is 'never' ) or whether the array should take liberty to suppress the separators for all of its members ( as I assumed when I wrote this email). The text of the specification is either silent or unclear on this point. Possible resolution: Rather than attempting to specify implied behaviours for the various occursCountKind settings, I believe the specification should a) prohibit the use of certain occursCountKinds within positional sequences b) require array occurrences to use the same SSP as other sequence members. After some discussion with the IBM team, I believe a) will not generate too many prohibited combinations, and the rationale for those prohibitions will be consistent with already-existing schema definition errors. b) will simplify the implementation of separation suppression, thus addressing the complexity problem. I expect we will need an action to be opened so that this can be discussed in the working group meetings. regards, Tim Kimber, IBM Integration Bus Development (Industry Packs) Hursley, UK Internet: kimbert@uk.ibm.com Tel. 01962-816742 Internal tel. 37246742 Unless stated otherwise above: IBM United Kingdom Limited - Registered in England and Wales with number 741598. Registered office: PO Box 41, North Harbour, Portsmouth, Hampshire PO6 3AU